Ultima Competition Series Especificaciones descargar pdf (Pagina 29)

Break-In Service and Hardware Re-torquing

With a new engine we feel the first oil/filter change should occur after the first 50-100 miles and all cover bolts and engine-mounting bolts

should be checked for proper torque. Keeping your engine oil clean is very important to the overall life of the engine. During the Break-In, or

look at it as the “Wear-In” period, engines produce very small metallic pieces that need a good filter to remove them. We do not recommend

extremely fine 10-micron filters during this time as they can clog quickly and begin to by-pass oil instead of filtering it. Use the 40 Micron

Filters during break-in and for the life of the engine. Ultima

recommends Ultima

Oil Filters, some examples are Midwest part# 25-78 & 25-79.

Checking cover bolts and engine mounting bolts is just good preventative maintenance during this period.

See Torque Specifications on the following page for Specifications.

Dyno Tuning

After your engine’s break-in procedure has been strictly adhered to we recommend that you have your engine dyno tuned for optimum

performance. Typically a new engine will have different fuel demands than an engine that has been through the break-in procedure and

additional tuning may be required for optimal performance.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Sin comentarios

Ultima Competition Series Especificaciones Pagina 29