Ultima SHOVELHEAD ENGINES Manual de servicio descargar pdf (Pagina 13)

 

See Picture 29

  

 

 

 

 

 See Picture 30



NOTE: At least one thick spacer will be required between breather banjo ttings and heads. Breather tting o-rings are easily damaged. It is suggested

that they be lubricated with light grease before installation. If possible, replacement o-rings should be obtained beforehand if banjo assemblies are

removed in future.

 





 See Picture 31.



 



      



NOTE: Backplate screws supplied with kit have pre-applied thread locking compound on threads. If screw without thread locking compound is used, a

thread locking compound such as Loctite® 242 must be applied to threads, and screws properly tightened. If screws are removed in future, Loctite® 242 or

equivalent must be applied before reinstallation.

Failure to apply thread locking compound or properly tighten screws may cause screws to loosen and fall into engine, resulting in engine

damage not covered under warranty.

Picture 29

Picture 30

Picture 31

CAUTION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comentarios a estos manuales

Sin comentarios

Ultima SHOVELHEAD ENGINES Manual de servicio Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Motor Ultima SHOVELHEAD ENGINES